VPG VanWeigh, Руководство по установке, настройке и калибровке

Страница: 27 / 82

27
How to install a steel axle transducer
A single axle transducer is used to monitor one side of an axle. In most cases, two axle
transducers will be installed per axle, one on the suspension for the left wheel, one on the right.
Ensure that you select the appropriate position for the sensor. Please see “Sensor installation
positions” on page 23 for guidance on selecting a position for a sensor
1. Clean and dry the surface where the transducer will be mounted to
the suspension system:
• Use brake cleaner and scotchbrite to remove heavy debris
• Use alcohol wipes provided to ensure all grease is removed
Loose paint and rust must be removed. The site must be dry before
installation
2. Ensure the mounting surface is at an appropriate temperature:
• The ideal temperature of the mounting surface is 70°F / 21°C
• If required, warm the spring with a hot air gun before bonding the
transducer
It is not recommended to apply the bonding tape at temperatures below 60°F / 15°C
3. Warm the bonding tape in your hands and apply it to the appropriate side of the sensor:
• The sensor must always be mounted with
the face adjacent to the groove pointing up
• The sensor must always be mounted with
the internal domain cable pointing towards
the pivot point on the suspension system.
Please see “Sensor installation positions” on
page 23 for further guidance on sensor
orientation in specific suspension systems
Mounted to the top
of the wishbone
Wishbone
pivot point
Side adjacent to the
groove facing up
Groove
Wheel
Mounted to the bottom
of the spring (bogie)
Spring
pivot point
Side adjacent to the
groove facing up
Groove
VanWeigh
®
VanWeigh
®