ICON 960 USER MANUAL
VPC
07/15/21
For more information visit vpc.com
RECEIVER MODULE INSTALLATION AND REMOVAL
PART # 310 124 XXX
TOOLS REQUIRED
Phillips Head Screwdriver
NOTE:
If the application requires, receiver modules can be
installed in the ITA and ITA modules can be installed in the
receiver (must use receiver Part # 310 124 103). If this is done,
you must be sure the contacts remain in the correct module
(receiver contacts in receiver module and ITA contacts in
ITA module). You should also use the keying kit to prevent
attempted mating to a receiver or ITA with an incorrect module
orientation.
RECEIVER MODULE INSTALLATION INSTRUCTIONS
1. Place the module in the receiver until the upper and lower
module screws touch the mating holes in the frame. Install
modules so that Pin 1 is located at the top of the receiver
frame (
Figure A
)
.
2. Using a Phillips head screwdriver, tighten the top screw 1-2 full
turns, while pushing lightly against the face of the module.
3. Maintain this pressure while tightening the bottom screw 1-2
full turns.
4. Repeat until the module is seated. Torque the screw to 1.5 in-
lbs [0.16 Nm].
RECEIVER MODULE REMOVAL INSTRUCTIONS
1. To remove, loosen the top screw 1-2 full turns. Loosen the
bottom screw 1-2 full turns.
2. Repeat until the module is separated from the receiver.
NOTE:
For optimum performance and system longevity,
distribute the contact load evenly throughout the module.
Figure A. The 2-56 module screws are designed with a captive
feature for loss prevention.
The iCon 960 receiver is designed so the modules mount
from the rear. This allows the user to easily mount wired
cable assemblies without having to route the connectors
through the receiver frame.
9