9050 USER MANUAL
VPC
07/19/2022
For more information visit vpc.com
5
ALWAYS SUPPORT THE RECEIVER AND PLATFORM
WITH THE MOST ROBUST (MIDDLE) SECTION OF THE
SLIDES.
4.
Remove the innermost section of each slide by extending the slides
fully, depressing the blue tab, and continuing to extend the inner
sections of each slide until it is free from the slide assembly (
Figure E
).
5.
Install the included instrument brackets. The shorter bracket is to
be installed for use with the top tier of slides and the longer on the
bottom. To install, follow the instrument bracket instructions also in
this User Manual.
9050TR INSTALLATION
1.
Install inner slides back into slide kit in the rack.
2.
Attach the platform mounting flanges to the inner slide rails on the
bottom tier using (6) 8-32 button head screws provided with the
receiver (
Figure F
). Do not fully tighten the screws.
3.
Attach the receiver mounting flanges to the top tier slides also using
(6) 8-32 button head screws. Ensure that the mounting surface
portion of the flange is directed outward as viewed from the front
(
Figure F
). Do not fully tighten the screws.
4.
Install the 9050TR platform/receiver onto the platform mounting
flanges with (6) 8-32 screws (
Figures E and F
). Do not fully tighten the
screws.
5.
Install the receiver mounting flanges on the top tier slides, to the back
of the receiver using the (4) receiver rack mounting screws provided.
6.
Pull the platform/receiver out as far as possible. The slides will lock
in position. Push the blue tabs located on the middle section of the
slides. Apply pressure to push the receiver back in toward the rack.
The smaller inner slides will move into the middle section, which
should not move. Push receiver until it backs against the rack.
7.
During regular use of the 9050TR, when not extended away from the
rack on the slides, the user should secure the receiver to the rack.
This prevents the unit from uncontrolled slide motion. To ensure the
receiver is correctly aligned with mounting hole locations on the test
rack, temporarily fasten the receiver to the rack using its captive 10-
32 screws. Be sure to provide support beneath the platform, lifting it
slightly to ensure an even screw engagement.
8.
Now, complete installation by fully tightening the previously installed
screws in this order:
1.
8-32 receiver mounting screws .
2.
8-32 button head platform mounting flange screws (
Figure F
).
3.
Front slide mounting screws (from slide mounting procedures).
4.
Rear slide mounting screws (from slide mounting procedures).
9.
The receiver may now be unscrewed from the rack and moved out
from the rack on the slides, if desired.
Figure G.
Figure F. Attach platform mounting flanges to the inner slide rails.
Figure H.
A
SLIDE
RELEASE TAB
INNER SLIDE
INSTALLING 9050TR WITH SLIDE KIT (CONT’D)
PART # 310 104 369, 310 113 451, 310 113 411, 310 113 500
Figure E.