The heater has been designed to allow leaving it inside the printer for long printing sessions.
However,
we cannot guarantee it will be completely safe under all and any circumstances
.
Operating
Placing Resin Heater to the printer
Be careful when placing the heater to the printer and removing it from there. Do not use force.
Verify that vat is placed precisely to it’s place on printer. Unaligned vat thus heater will be hit by
building plate of the printer and cause fatal damage to printer’s LCD, vat’s film and heater.
Keep the controller unit safe from resin splatters and stains. The unit is relatively resistant against
small splashes of liquid, but the power jack and the MicroUSB jack are not weather resistant.
Printer: Photon / Photon-S
Put the vat into printer slightly angled as an image below:
Place the Heater in the vat as on image below. You may need to do this in two phases, first pushing
the vat in, then moving the heater a bit, then moving the vat again. Repeat such a movement few
times until vat slip into place.
