Resin Heater User Guide
Version 1.0
© 2020 VP-Systems. All rights reserved.
Rights to change the instructions or the product reserved. Some parts may look different than in the
pictures.
Contents of the package
Heater frame with controller
AC/DC Power adaptor (110V/220V -> 12V / ~60W)*
Power cable (110/220V)*
Power extension cable with 5.2mm plug and jack on both ends**
Power splitting cable with two 5.2mm jacks and one plug on both ends**
* Only if purchased together with dedicated Power Supply
** Only if purchased without dedicated Power Supply
Parts and their functions
1. Display
2. Control buttons
3. MicroUSB connector for firmware updates
4. DC power connector ( 5.2mm, inner pin is + terminal)
⌀
5. Chassis protrusion for fixing the heater into the resin vat/printer
6. Heating elements
7. Temperature sensors
Safety precautions
Check the heater for scratches or other damage.
Do not use it if there is any visible damage.
The heater has built-in safety measures. It cuts off the heating power if it detects something
potentially harmful, high voltage/current, abnormal behaviour of controller or any other unexpected
behaviour. However, it is still possible that an external damage causes a short-circuit which cause
excessive heat and can be dangerous.
