128-9295
3 of 4
3
UNLOCKING THE VEHICLE:
If you have an electric door lock, and the Optional Unlock feature was added, with
the vehicle running under command of the remote start unit, press and hold the
transmitter button for 3 seconds until the doors unlock.
CAR FINDER MODE:
Anytime the vehicle is not running under control of the remote start unit,
within operating range of the vehicle, press and hold the push-button of
the hand held transmitter for 4 seconds to activate the car finder mode.
The vehicle lights will flash for 30 seconds or until the push-button is again pressed
and released.
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it.
This is an upgrade that can give you control of certain functions of your vehicle
from a telephone, or in some cases a computer interface. Please check with your
installation center for most recent Telematic Upgrades. If you had a Telematic
Upgrade installed, the manual supplied with the upgrade unit will provide an
operator's manual advising of the features of the system and means available to
control these features of your vehicle.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
The Transmitter Model Names 14XR1Pr & 14XR2Pr are also
Found On Back Of Transmitter Case.
Use Battery CR2032 For 14XR1Pr & 2 CR 2032's For 14XR2PR
1. Turn the ignition key to the ON position.
2. Press and release the valet/programming switch 3 times (Siren Chirps).
3. Press the Transmitter Button of each transmitter you want programmed until you
hear a chirp from the horn or siren or the Parking Lights Flash
4. Turn the ignition switch off.
The above action programs the Start function for this system.
Transmitter Battery Replacement
1) Locate and remove the two "00" point Phillips head screw on the back of the
transmitter case.
2) Carefully separate the front case from the rear.
3) Slide the CR2032 battery out from under the battery clip and dispose of
properly.
4) Install the new battery with the (+) side facing up away from the circuit board.
5) Close the case and reassemble in reverse of disassembly
