128-9295
2 of 4
2
REMOTE STARTING THE VEHICLE
This will not start the vehicle if any one of the following situations
exists:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the OFF position.
1. To start the vehicle, press and release the
t r a n s m i t t e r b u t t o n t w o t i m e s w i t h i n
2 seconds. The vehicle will start and remain
running for the pre-programmed time of up to a
60 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending
on the setting by your installation center.
Additionally if the two way transceiver (shown right) is used, the
transceiver will play a melody when the vehicle is started, and the Orange LED
surrounding the button will flash every ten seconds while the vehicle is running.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the
spring loaded start position), then step on the brake pedal to disengage the remote
starter. The vehicle will continue to run, but now on its own power.
NOTE:
The engine will stop running before the pre-programmed run cycle has
expired if you perform any one of the following functions:
Press and the button on the keychain transmitter two times within 2 seconds
Depress the brake pedal
Open the vehicle's hood
Place the unit in the safety control disabled mode.
PUSH BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily
disable the remote starting function of the system. This is recommended whenever
the vehicle is being serviced. To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, press and hold
the Push-Button, found on the windshield receiver.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flashes and
continues this pattern until returned to normal mode of operation. This puts
the unit into the R/S Override mode indicating that the remote start is in the
service mode and will not start from RF or any other input Posse or otherwise.
To Exit R/S Override Mode:
1. With the system disarmed, press and hold the Push-Button, found on the
windshield receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off indicating that the R/S unit is fully functional once again.
