15
R
ESTORING
THE
FACTORY
SETTINGS
Here’s how you can restore the factory settings.
NOTE:
If you do this, the programs you saved in the channels will be completely erased,
and will be reset to the factory settings.
NOTE:
Effect and noise reduction settings made in the Manual mode will also be erased.
1. Turn the power off.
2. While holding down both the CH and WRITE buttons, turn the power on.
When the CH1 and CH2 LEDs begin blinking, release these two buttons.
HINT:
If you decide to abort this operation, press the TAP switch at this point.
3. When you press the WRITE switch, the CH1 and CH2 LEDs will change from
blinking to lit. Initialization will be completed in a few seconds, and the amp
will switch to Preset mode.
NOTE:
Never turn off the power while initialization is taking place.
