Vox Night Train 15C1, Руководство пользователя

Страница: 4 / 18

4
3. BRIGHT CHANNEL Indictor
– When using the BRIGHT channel, this is illuminated GREEN. When
using THICK mode, the indictor becomes ORANGE.
4. THICK Switch
– When THICK mode is engaged, TONE controls are bypassed to give a big boost in
gain. This mode is foostwitchable using the optional VFS2A footswitch. Set to “THICK on” when using the
optional VFS2A footswitch. (NOTE: THICK mode only works on the BRIGHT channel. When this is on, the
tone controls aren’t!)
5. GIRTH CHANNEL Indicator –
When using the GIRTH channel, this is illuminated RED.
6. GIRTH GAIN Control –
Use this to adjust the gain on the GIRTH channel. Crunchy Rock tones before
12 o’clock and searing Lead tones when fully cranked.
(NOTE: Because of the nature of the design of this amplifier, it may take a few minutes until the circuit
becomes stable after the power is turned on. Some noise might occur during this time but it soon
disappears.)
7. GIRTH VOLUME Control – Use this to control the overall level of the GIRTH channel, helping to balance
the outputs of both channels.
8. BRIGHT / GIRTH Channel Switch –
Use this to change channel. This is footswitchable using the
optional VFS2A footswitch. Set Channel Switch to GIRTH when using the footswitch.
9. TREBLE Control –
This controls the treble (high) frequencies in your sound - from soft and round when
turned down (counter-clockwise) to bright and cutting when cranked (clockwise) and all points in-between.
10. MIDDLE Control
– This controls the middle (mid range) frequencies in your sound. From hollow when
turned down (counter-clockwise) to full and rich when cranked (clockwise) and all points in between.
11. BASS Control
– This controls the bass (low) frequencies in your sound - from warm and light when turned
down (counter-clockwise) to dark and heavy when cranked (clockwise) and all points in between.
12. REVERB Control
– Use this to add ambience to your tone, subtle when turned down (counter-clockwise)
and “surfy” when cranked (clockwise) and everywhere in between.
13. MASTER VOLUME Control
– Use this to control the overall level of the amplifier, whilst retaining all the
tonal characteristics.
14. DARK Switch -
Use this to tame the higher frequencies, giving the Amplifier a whole different character.
15. STANDBY Switch
– Puts the Amplifier into STANDBY Mode. Meaning no output, just nicely warmed Tubes.
16. MAINS Switch
– Turns the Amplifier On or Off!
17. MAINS Indicator – Shows whether your Amplifier is On or Off.
REAR PANEL LAYOUT
1. FX SEND Jack
– Connect this to the input of your effect. (NOTE: This is a series effects loop).
2. FX RETURN Jack
– Connect this to the output of you effect.
3. FOOTSWITCH Jack
– Connect the optional VFS2A footswitch here, allowing for hands free control of
mode and channel switching.
4. 16 OHM Speaker Jack
– Use this to connect the Night Train to any 16 ohm Cabinet.