Vox Technologies EM-350A, Руководство пользователя, Страница: 12 / 66

JUMPER SETTINGS AND CONNECTORS
EM-350 / 6
2.2 J
UMPER
S
ETTING
O
VERVIEW
In order to select the operation modes of your system, configure and set the jumpers on
the your SBC to match the need of your application. To set a jumper, a black plastic
cap containing metal contacts is placed over the jumper pins as designated by the
required configuration as listed in this section. A jumper is said to be “ on ” or “ 1-2 ”
when the black cap has been placed on two of its pins, as show in the figure below:
A pair of needle-nose pliers is recommended when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local sales representative before you make any changes. In general, you simply
need a standard cable to make most connections.
2.3 I
NSTALLING THE
SODIMM M
ODULE
:
A SODIMM module simply snaps into a socket on the system board. Pin1 of the
SODIMM module must correspond with Pin1 of the socket.
1.Position the SODIMM above the socket with the “ notch” in the module aligned with
the “ key” on the socket.
2. Seat the module 15 degree into the bank. Make sure it is completely seated. Push
down it to lock the two sides.
Pin1
Notch
Key