DE
EN
FR
IT
NL
SV
ES
PL
25
85285 - 07.2021 - V5
INSTRUCTION MANUAL VOSS.FARMING EASYCUT
EN
Motor
Fault/Problem
Cause
Solution
Motor gets hot
1.
Air filter clogged
2. Blade tension is too
high
3.
Blade and/or head
are dry
4. Defective ball
bearing
1.
Clean or replace the air filter.
2. Reduce the tension of the blades
with the tensioning nut. If this
solves the problem and the
machine stops cutting, the blades
must be sharpened.
3.
Lubricate the blades/ clipper head.
4. Contact the service department.
Motor vibrates
1. Rotor runs out of
round
2.
Bearings are worn
out
3.
Fan wheel broken
Contact the service department.
Motor is very loud
Bearings seized up
Contact the service department.
Clippers head/Blades
Fault /Problem
Cause
Solution
Upper blade is not
moving
Defective reduction
gearing
Contact the service department.
Upper blade does
not move over
the entire running
surface
1.
Eccentric knocked
out
2. Eccentric shaft
defective
Contact the service department.
Clipper head gets
very hot
1. Blade tension is too
high
2. Blade or head are
dry
1.
Adjust the blade tension with
the tensioning nut. If this solves
the problem and the machine
stops cutting, the blades must be
sharpened.
2.
Oil the blades/clipper head.
Blades cut badly
1. Blade tension is too
low
2. Blades have rust on
them
3. Blades are dull or
poorly sharpened
1.
Increase the blade tension with
the tensioning nut.
2. Have the blades sharpened in
a specialist shop. If there is too
much rust, replace the blades with
new ones.
3. Have the blades sharpened in a
specialist shop.
