15
Installation
CA-RM ES models
ENGLISH
3
Manicotti opzionali
2 CA-RM ES
in serie
4
passacavo
alimentazione
passacavo
segnale
5
ATTENTION
The screws of the hose clamps for tightening the optional rubber sleeves (Fig.3: X) must be tightened in
accordance with the following parameters:
-Thread diameter: 6 mm;
-Torque: 2.5 Nm;
If a dynamometric tool is not available, proceed as follows:
Tighten the 6 mm screw to the end of its travel; after this operation, provide additional safety tightening, not
exceeding ¼ turn.
Optional couplings
2 CA-RM ES
in series
Power supply
grommet
Signal
grommet
NB: install the appliance with the grommets facing
upwards
NB: the IP47 degree of protection is guaranteed if the
following connectors are used with the KIT FSG
accessory:
STEAB
PAGURO 5695/1 for the power supply and
STEAB
PAGURO 5633/6 for the signal
Installation in manhole