Vortex VX1500D, Руководство пользователя

Страница: 20 / 32

6
VX1500D
- 2 - FUNCTIONS AND SETTINGS
2.1 Operation
Note that fog machines develop condensation around the output nozzle. This may result in moisture accu-
mulation on the surface below the output nozzle. Consider this condensation when installing the unit. All
fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off. The led lights upon the fog machine after being plugged in properly. After a few minutes
of warm-up time, the fog machine will be in “ready to fog” condition.
NOTE: the LED on the bottom of the tank indicates the fog fluid level; when it flashes, the fluid level is low
and requires refill, the pump stops simultaneously. Simply refill the tank, the pump will function again.
ADD PROLIGHTS FLUID IN TIME IF THE SMOKE MACHINE KEEPS RUNNING WHEN IT HAS RUN OUT OF
FLUID. ITS PUMP WILL BE DAMAGED!
Place the unit on a horizontal surface;
- Unscrew the tank cap.
- Fill up the fog fluid container (SMOKEFLUID series). If any fluid is spilt, wipe it off immediately with a dry
cloth. It must not get inside the unit.
- Tightly close the tank. Make sure that the suction hose will reach the bottom of the tank.
- Connect the wireless control KT-1 to the socket inside the housing.
- Plug main power cord from the fog machine into the appropriate power supply socket. Wait a few min-
utes for heating element to heat up.
- When the heating process is completed the fog machine is ready for use.
- Refer to the section of the manual “Set-up”.
- If fog is emitted continuously for a long time, the heating element temperature may drop, shutting off
fog production. If so, please do not activate fog emission. Wait briefly. When the heating element tem-
perature rises, fog emissions can be resumed.
Warning: while filling up the fog fluid container (SMOKEFLUID), the unit must not be connected. Disconnect
the main plug from the socket first! The unit is not splashproof. If fluid accidentally gets inside the unit, do
not set the fog machine into operation; it must be cleaned and checked by skilled personnel first.
2.2 Set-up
After the heating is completed, the led allows on the control panel lights up in blue color to indicate that the
machine is ready for use. When TIMER function is activated, the fogging duration is adjusted by SECONDS,
MINUTES which a sets the amount of time in between every fog output, VOLUME adjusts the fog volume.
When MANUAL button turns on, the machine emits fog continuously.
NOTE: the average working temperature for the unit must be under 250° degrees (centigrade).
WARNING: before removing or replacing the remote control unit disconnect the power cord.