VorTek SonoPro Professional S36 Series, Инструкция по эксплуатации

Страница: 27 / 108

Series S36 Instruction Manual Chapter 2 Installation
800120 2-15
3. With the mounting bracket in one hand and one U-Bolt in the other hand,
place the U-Bolt around the 2-inch pipe in which the flowmeter is to be
mounted and through one set of holes in the center of the mounting
bracket as shown in Figure 2-16.
Figure 2-16. Mounting Bracket with U-Bolt
4. Thread the two nuts that were removed from the U-Bolt in Step 2 back on.
Move the mounting bracket to the desired location. Tighten the nuts down
fully ensuring the bracket stays straight and level. The assembly should re-
semble that of Figure 2-17.
Figure 2-17. Mounting Bracket with U-Bolt and Nuts
5. Place the second U-Bolt around the pipe and through the set of holes in the
center of the bracket that were not used in Step 3 (these can be either the
top or bottom Holes).
6. Thread the two nuts that were removed from the U-Bolt in Step 2 back on.
Tighten the nuts down fully. The assembly should now resemble that of
Figure 2-18.