Vorsis VP8 Plus, Примечание к применению

Страница: 21 / 42

Setting the Input Audio Levels
- Connect the Analog or Digital audio inputs as appropriate for your
installation.
- Start up the VP-8 GUI Lite application and configure a device if
you haven’t done so already and then connect to the unit.
- Click on the Calibrate Input/Output Menu tab at the top of the
GUI and select the input source to match the Input type you
connected to the rear panel. If your audio source is already
providing an audio feed, you should see meter activity on the Input
and Output meters.
While still in the Input menu and observing
the Input meters within the GUI or on the
front panel, adjust the Input Gain control
(AES or Analog as required) until the input
meters are peaking around the -12dBFS
“Ref” marking with normal program levels
applied.
NOTE: To ensure proper headroom inside
the processor’s algorithms frequent peak
levels exceeded the -12dBFS “Ref” marking
on the Input meters are strongly
discouraged.
INPUT OUTPUT
METERS METERS
Setting Output Audio Levels
Now it’s time to make the audio output connections as appropriate for
your installation and adjust audio output levels. We’ll use the VP8’s FM
Mode for this example, although the procedure is similar for all six of
the VP8’s processing modes.
If using the Analog outputs pre-emphasized, navigate to the Calibrate
Input/Output screen and select the checkbox for Analog Out Mode:
L/R. Then adjust the Analog Output Gain control to set the correct
output level.
21