6
English
before operating the appliance again.
-
Note:
Heaters draw more current than small appliances,
overheating of the outlet may occur even if it has not occurred
with the other appliances.
- This product’s power cord is equipped with a three-prong,
grounded plug that must be inserted into a grounded
receptacle. Connect to properly grounded outlets only.
- This heater is for use with 120 volt electrical outlets. Connect
to properly grounded outlets only. The cord has a plug as
shown at A in Figure 68.1, below. An adapter as shown at C is
available for connecting three-blade grounding-type plugs to
two-slot receptacles. The green grounding lug extending from
the adapter must be connected to a permanent ground such
as a properly grounded outlet box. The adapter should not be
used if a three-slot grounded receptacle is available.
- Before moving, repositioning, servicing, cleaning and when
not in use, use the product controls to turn off the power
and then unplug. To disconnect from outlet, grasp and pull
only the plug. Also, power off and unplug if the product will
be left unattended for an extended period of time or during
electrical storms.
- If your heater suddenly stops working:
• This heater is equipped with a thermal cutout safety feature
designed to automatically shut off when overheating is
detected. See the “RESET HEATER” instructions in this guide
to determine how to check and reset the heater.
• If the heater and other electrical products suddenly stop
working at the same time, your home circuit breaker
or fuse may have tripped due to an overload of power.
Consider only running your heater on the “low” setting,
only running one heater at once and unplugging all
other electrical products while running the heater, and/or
hiring an electrician to install an additional circuit to your
home’s electrical system.
SERVICING WARNING — To reduce risk of fire, electrical shock
and injury to persons, observe the following:
- Clean your product regularly, only as is instructed in this
manual. Prior to cleaning, turn off the power on your product
and unplug. Do not use gasoline, thinners, solvents, ammonias
or other chemicals for cleaning. Refer to the CLEANING
instructions provided.
- Do not open appliance housing while product is plugged in.
To avoid risk of shock, all service and/or repairs must be done
by a Vornado Authorized Service Center.
SAVE THESE INSTRUCTIONS
Figure 68.1
