12
English
TROUBLESHOOTING
POSSIBLE CAUSE AND SOLUTION
PROBLEM
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker
/ ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Tip-over switch on bottom of unit has been tripped and safety shut-off system has cut power to heater.
Place heater on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to High Heat and thermostat is set to highest temperature setting.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
Press the Power button Off and unplug unit. A cylindrical plunger is on bottom of unit. Push in 4-5 times,
ensuring it is not stuck. Set unit down on flat surface. Ensure power cord is not under unit. Plug unit in and
press Power button On. Turn to highest heat setting.
Unit fails to power on.
Unit is not producing
sufficient amount of heat.
Unit is powered on but
there is no heat.
