5
English
unplugged quickly during an emergency.
- Do not modify the product with any aftermarket accessory.
SAFE USE WARNING—To reduce risk of fire, electrical shock and
injury to persons, observe the following:
- Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or
injury to persons.
- Extreme caution is required at all times a heater is in operation.
Always unplug heater when not in use. Vornado does not
recommend unattended and unsupervised use of this heater.
- This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. If provided, use handles when moving
this heater.
- Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip).
Do not use this heater on a surge-protected unit or Ground Fault
Circuit Interrupted (GFCI) outlet. Note: GFCI outlets are typically
found in bathrooms and kitchens and feature a “reset” button to
prevent tripping of an electrical circuit.
- Before plugging power cord into electrical outlet, be sure that
all electrical information on the rating label, including voltage, is
compatible with your outlet’s power supply.
-
WARNING:
To reduce likelihood of circuit overload, fire and electric
shock, do not operate with a solid state speed device, such as a
dimmer control switch. Use of this appliance on the same electrical
circuit as another high energy use product, such as a vacuum
cleaner, blender, variable speed fan or circular saw is not advised.
Do not use this heater with a timer designed to automatically turn
the unit on or off, as this may accidentally disable the heater’s
thermal cutout safety feature.
- Risk of fire. Do not operate if it has been dropped or if damage is
apparent to any part of the unit including the cord and plug. Only
original replacement parts may be used.
- Never use the cord as a handle or otherwise yank, strain or stretch
the power cord.
- While the product is plugged in, do not insert or allow foreign
objects to enter any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the heater.
- Check your heater cord and plug connections. A loose fitting outlet
can cause the plug to overheat or cause a fire. Be sure plug fits tight
in the outlet. Check frequently during use to make sure plug and
outlet are not hot. If so, discontinue using heater and have outlet
replaced by a qualified electrician.
- Never ignore the signs of an electrical problem, such as: warm
outlet coverplates, sparks when plugging in or operating, lights
flickering/dimming during operation. Immediately turn off and
unplug the appliance if any such problems are noticed. Contact a
qualified electrician to investigate possible causes before operating
the appliance again.
-
Note:
Heaters draw more current than small appliances,
overheating of the outlet may occur even if it has not occurred with
the other appliances.
- This heater is for use with 120 volt electrical outlets. The cord has
a plug as shown at A in Figure 65.1, below. An adapter as shown
at C is available for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding lug extending from
the adapter must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
