VOP CeramicMaster E20, Руководство пользователя

Страница: 9 / 17

Ceramic Master E20 en v1 9
PARAMETERS AND PROGRAMMING
In order to change the value of a parameter it is
necessary to do the following steps:
There are two possible ways of leaving the programming
mode after you have finished with the changes in the
parameters’ value:
FIRST EXIT:
SECOND EXIT:

With the multi functional rotary knob MFK chose the
program which parameters you want to change;

Press button PROG . Indicator of the button RUN
begins to blink green/red and you can see on the
display:
XXX : YYYYYYYYYY SEE
PROGRAM NAME
The letter expressions means:
ХХX - number of program;
YYYYYYYYYY - name of program;
SEE - view data;
PROGRAM NAMЕ - parameter which to be
changed.

PROGRAM NAMЕ is the first parameter which is
shown when you enter in PROGRAM mode. Turn
left/right the
MFK in order to chose the parameter
you want to change;

Press button RUN in order to chose the value of the
parameter you want to change. If you have chosen
the first parameter you would see on the display:
XXX : YYYYYYYYYY SET
PROGRAM NAME
Indicator of the button
RUN turns off and the red
indicator on the button STOP begins to blink.

Turn the MFRK to change the parameter value.
Press button STOP in order to leave the programming of
the current parameter. Indicator of the button RUN starts
to blink again in green/red which means that it is possible
to program the next parameter.
press button
ESC . This will CANCEL all the changes that
are made in the parameters’ value in the program.
press button
PROG . This will SAVE all the changes that
are made in the parameters’ value permanent.
The indicator of button
RUN will flash in green in working
mode if the temperature defined by the parameter IDLE
TEMP is reached and if the temperature is not
reached it will flash in red.