Vook VHA30, Инструкция по эксплуатации

Страница: 4 / 8

4 13
Before installation, position the location where the controller unit is
mounted. Please operate it according to the following steps:
1. Open the controller by loosening and removing the back case
screw at the bottom with the spline tool.
2. Use the provided drilling template to accurately locate and drill
the required holes. The four drilling holes are marked "B".
3. Use the screws provided to mount the back case on the wall. Be
sure to draw the wiring through the large centre hole in back
case, and keep level.
4. Connected accurately the system wiring following the label
enclosed on the rear.
5. Put the unit back and screw it on by using the spline tool.
INSTALLATION
Black+White 485-
Shielded ground
Red-power DC input +12V - +24V
Black-power AC input V - 24V
Brown-door status detecting
Orange-unlocking button 1
Yellow-unlocking button 2
Green-GND
Blue-NO 2
Purple-COM 2
Gray-NC 2
White-NO 1
Pink-COM 1
Aqua-NC 1
Black+white-485-
Brown+white-485+
Shielded ground
Ł
Ł
~ 12
DC input +12V - +24V
AC input V - 24V
Ł
Ł
~ 12
Pay attention for
right polar connection
Brown+White 485+
Door
bell
Door lock
VHA30N RS-485 Wiring Diagram