VooDoo DCR 6000, Планирование и монтаж: Руководство

Страница: 91 / 149

4. Connections DCR 6024/6128/6000
4 – 14 Planning and Installation – Rev. 1 / 7. 2001
4.5.5 REMOTE CONTROL REM 1, REM 2, REM 3, RS 232C
REM 3
REM 1
TERM
RS 232C REM 2
OUT IN
REMOTE
ON
OFF
Fig. 413: Remotes
Remote control connections for REMote mode. The desired interface is selected
in the REMIF submenu (see Operating Instructions, section 4.12.4)
RS 422 loop input (9 pole D-sub)
This input is used to control the machine via the ES-BUS protocol. If the signal is
not looped to a further unit, the input has to be terminated with the switch located
at its side (TERM-ON).
This socket serves (9 pole D-sub) for the control of the DCR 6024 by editing sys-
tems (e.g. BBE), graphic systems and film to tape productions via the RS 422A pro-
tocol.
This socket serves (9 pole D-sub) for the control of other equipment via the
RS 422A protocol.
Remote interface for Data Switch DSW 6000.
Serial RS 232C interface (9 pole D-sub) for connecting a terminal for Thomson
service.
REM 1
REM 2 IN
REM 2 OUT
REM 3
RS 232C