VONROC RH502AC, Оригинальное руководство пользователя

Страница: 8 / 64

8
EN
WWW.VONROC.COM
The On/Off switch (Fig. A)
• Switch the machine on by pressing the On/Off
switch (2). When releasing the On/Off switch (2)
the machine will turn off.
• The rotation-speed can be continuously adjus-
ted by pressing the On/Off switch (2) deeper or
less deep.
Lock­on button (Fig. A)
• Lock the On/Off switch (2) by pressing the On/
Off switch (2) and then pressing the lock-on
button (4).
Switching the direction of rotation (Fig. A)
• Direction of rotation counter-clockwise: shift
left/right switch (1) to “ ”.
• Direction of rotation clockwise: shift left/right
switch (1) to “ ”.
This function is only available when the machine is
set to “drill mode” (As shown in fig. D function A & B).
Function selection switch (Fig. C, D)
In order to avoid damage to the machine,
adjusting the function selection switch (5)
shall only be done when machine is not
running. Fig. C
The correct position of the function selection
switch (5) for each function is shown in the pictu-
res in fig. D. Always make sure the function switch
clicks in the desired position.
A) Drilling (without hammer function): for drilling
in several materials.
B) Hammer Drilling (with hammer function): for
drilling in masonry such as brick, concrete and
similar material.
C) Chisel angle adjustment: for changing the angle
of the chisel. When set under right angle switch
back to position D. before using the tool.
D) Chipping (chisel function): for chipping and
small demolition jobs.
User tips
• For large holes, for instance in very hard con-
crete, start using a smaller bit for pilot drilling
first, then drill to nominal size.
• Hold the machine firmly with 2 hands. Be aware
the drill can jam and because of that machine
might suddenly turn (especially when drilling
deep holes).
• Do not apply a lot of pressure on the machine,
let the machine do the work.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.