EN
5
WWW.VONROC.COM
sons not capable of leaving the room on their own,
unless constant supervision is provided. The device
is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse.
TECHNICAL SPECIFICATIONS
Model No.
PH501AC
Voltage
220-240 V~
Frequency
50-60 Hz
Power
1500W
Heating element type
Carbon fibre lamp
Heating time
3 seconds
Wave length
3.0-1000 microns
Radiant efficiency
90%
Heating distance
2-3m
Heating area
7-9m²
Colour temperature
1600 K
Overheat protection
Yes
Electronic soft start
Yes
Ingress protection class
IP44
Protection class
Class I
Weight
2.36 kg
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Hanging chain
2. Power cable
3. Hanging hook
4. Carbine hook
5. On/off switch
6. Heater
7. Protective grill
8. Remote control
9. Remote control switch
10. Receiver for remote control
3. ASSEMBLY
This heater should be installed by a
competent person, i.e. a qualified electrician.
Always disconnected the heater from the
electrical supply and allow it to cool before
installation.
Installing the heater (Fig. A, C)
Always mount the device with the supplied
accessories.
Before starting the installation, take the following
into consideration:
• Place the device on a firm, level ceiling surface;
installation of the heater should be on a strong
rigid support (such as strong wooden beams or
metal rails etc).
• The device must be hung so that there is 50
cm of free space between the heater and any
ceiling, tent canvas etc. There must also be
at least 1.80 m between the ground and the
underside of the device. Refer to Fig. C. The
device can never be hung on a hook in the wall
as it could hang at a slant!
• The Hook used to hang the heater must be able
to take a weight 3 or 4 times that of the heater
itself.
• Ensure that the power supply cable is well
mounted and that it does not come into contact
with reflector of the heater or that does not trail
into heated area.
• Do not install the heater on an inflammable
surface.
• If the heater is to be used outside, a weatherp-
roof outlet is highly recommended.
• Before drilling ensure that there are no wires or
water pipes in the area where the heater is to
be installed.
To install the heater, follow these steps:
• The device is supplied with a hanging chain (1)
and two carbine hooks (4). Put a carbine hook
(4) on both ends of the chain (1).
• Mount one side of the chain onto the hanging
hook (3) using the carbine hook (4), as shown
on fig. A.
• Provide an attachment point from which the
device can hang down freely and that is sturdy
enough to hold the heater without any pro-
blems. Fix it firmly in such a way that it cannot
drop, slip, slide or otherwise move.
• Attach the unused carbine hook (4) on the
heater chain onto the provided ceiling hook or
ceiling hanging eye.
• Take into account the minimum distances as
shown on figure C.
• Plug the patio heater into a grounded power
outlet. Check beforehand if the voltage rating
Содержание PH501AC
Страница 2: ...WWW VONROC COM 2 A B C 4 5 7 9 8 10 1 2 3 6...
Страница 54: ...54...
Страница 56: ...2020 VONROC WWW VONROC COM 2012 21...