VonHaus 3500219, Руководство пользователя

Страница: 6 / 22

A5P | 01
SECURING THE SANDER
WORKBENCH: If the Belt and Disc Sander is to be used
in a permanent location, it should be fastened securely
to a firm supporting surface such as a workbench.
NOTE: Mounting Bolts not supplied.
• Place the Bench and Disc Sander in the location you
require and mark the 2 holes on the base.
• Drill the holes using a 3/8” Drill Bit.
• Place the Bench and Disc Sander back into the
choosen location and align up holes.
• Using the Hex Bolts (Not Supplied) secure the Belt and
Disc Sander.
NOTE:
Bolt length should be 1.1/2” plus the
thickness of the bench top.
CLAMPING: If your Belt and Disc Sander is to be
used as a portable tool, it is recommended you fasten
it permanently to a mounting board that can easily be
clamped to a workbench or other stable surface.
The mounting board should be of sufficient size to
avoid tipping while Belt and Disc Sander is in use. Any
good grade plywood or chipboard with a 3/4 in. (19
mm) thickness is recommended.
CONTENT LIST
1. 80 Grit Sanding Belt (760 *25mm) 860/min
-1
2. 80 Grit Grinding / Sanding Disc (Ø 125mm)
3. Sanding Belt Tensioning Screw
4. Sanding Belt Unlocking Screw
5. 45° Adjustable Belt Table
6. Mitre Guide
7. 45° Adjustable Disc Table
8. Disc Table Adjusment Screws
9. Safety Belt Cover
10. Safety Belt Locking Screw
11. On/Off Switch
12. Sanding Belt Dust Outlet
13. Sanding Disc Dust Outlet Cover
14. Sanding Disc Table Adjusment Lever
15. Hex Key
1 x 120 Grit (25*760mm) Sanding Belt
1 x 240 Grit (25*760mm) Sanding Belt
1x 120 Grit (Ø 125mm) Sanding Disc
1x 240 Grit (Ø 125mm) Sanding Disc