VonHaus 3500014, Инструкция по эксплуатации

Страница: 8 / 14

6
FITTING/REMOVING A SAW BLADE
CAUTION: Always ensure that the tool is powered off and disconnected from the
mains before performing any adjustments or maintenance.
CAUTION
Do not use worn or damaged saw blades
as this can cause injury to the user and/or damage to
the tool.
IMPORTANT Ensure you use the correct type of saw
blade, specific to the material to be cut.
To insert a blade, firstly rotate the Chuck Collar (2) in
an anticlockwise direction. This will retract the pin and
allow the required Saw Blade to be inserted.
Take the saw blade and insert into the centre of the
Chuck Collar (2) . Ensure the teeth are facing in the
correct direction before sliding the blade into the slot
on the Chuck Collar as far in as possible.
Release the Chuck Collar (2) to secure, and check that
the blade is in place.
To remove a worn/damage blade, follow the above
steps in reverse.
ADJUSTING THE SHOE PLATE
The Shoe Plate (1) slides in and out to adjust the
effective stroke length for maximum control and
longer blade life.
Loosen the two
Hexagonal Shoe Adjustment Screws
(7) with the Hex Key (8) provided.
Pull the Shoe Plate (1) to the desired position, and
re-tighten the Hexagonal Socket Screws with the Hex
Key (8)
provided.
CAUTION: Always ensure that the tool is powered off and disconnected from the
mains before performing any adjustments or maintenance.
1
7
WARNING! Always wear protective gloves
when handling blades.
WARNING! Do not remove the blade
immediately after the cutting; the blade may
be very hot.
2
1
8