7
Remove existing exit device
and old strike from door.
Exit device
Match master cam function
for new XP device to that of
removed exit device.
4
NL drive
screw
A.
Inspect underside of old center case for master cam.
B.
If NL drive screw (shown below) has been removed, it
must be removed from new XP center case as well.
If NL drive screw is present in old center case, leave
NL drive screw in new XP center case.
Lock
slide
Master
cam
RETROFIT INSTALLATION
2
Install new 909 strike to
replace 299/299F strike.
A.
Re-drill and tap existing center strike hole for 1/4”-20.
B.
Attach strike to frame with new center screw and
locking plate and position strike against door.
C.
Mark and prepare 2 outer holes for 1/4”-20 and
install screws.
Existing center
strike hole
Locking
plate
1
3
Mark and prepare 2 new
support holes in door.
A.
Align plastic template with existing holes as shown.
B.
Mark 2 new holes as shown.
C.
Prepare 2 new holes per chart below:
#25 Drill
#10-24 tap
Met
al
W
oo
d
1/8” Drill
pilot 1” deep
2 new holes
Plastic template
Go to page 5-6 and continue
device installation steps 7-10.
909 strike
*See page 11 for 954 installation
NOTE:
If plastic template will not align correctly with the 4 outer holes,
bolt new XP exit device on door temporarily with the 4 screws
and use it as a template to mark the 2 holes shown above.
Old 299/299F or 499F strike cannot be used
with XP98/99 device. Strike must be
removed and replaced with new strike.
Old strike Replace with
299/299F
909
499F
954*
CAUTION
!
