Volvo VHD, Руководство по обслуживанию

Страница: 41 / 104

Group 170 Preventive Maintenance
Clutch Bearing and Cross Shaft
The Volvo Clutch Release Bearing is sealed for life and
does not need lubrication. However, the cross shaft must
still be lubricated.
Vendor clutch cross shafts and release bearings need to
be lubricated. The cross shaft bearings are remotely lu-
bricated by a hose. The grease fitting is located on the
right side of the bell housing.
Grease the release bearing — but do not overgrease.
Driveshafts
When greasing a driveshaft U-joint, it is very important
that grease comes out of each of the four bearings. If
grease does not come out of a seal, move the shaft from
side to side.
If a U-joint cannot be fully greased, note it on the form
for further inspection.
CAUTION
An ungreased U-joint bearing will fail after a short
time.
If vehicle is equipped with a PTO that has a driveshaft,
lubricate its U-joints.
Volvo T-Ride
1 Remove the pressure relief valve located at A and
install a grease fitting.
2 Remove the grease fitting at B
3 Fill with grease through A fitting until grease oozes
out of B.
4 Install the grease fitting at B and fill it with grease
until it oozes out around the entire seal (See arrow).
5 Remove the grease fitting at A and reinstall the
pressure relief valve.
It is important that the bearing is completely filled with
grease. This becomes very important if vehicle operates
in wet areas. If operating in places where driving through
water, lubricate daily to force water out of bearing area.
39