Volvo V60 Twin Engine, Руководство пользователя

Страница: 349 / 440

WHEELS AND TYRES
}}
347
6.
Remove the valve cover
27
Take the torx wrench (which is fitted in the
foam block behind the panel on the left-hand
side of the cargo area).
Press the torx wrench into the hole.
Prize off the cover using the torx wrench (A).
7. Unscrew the tyre's dust cap.
Check that the pressure reducing valve on
the air hose is fully screwed on, and screw in
the air hose's valve connection to the bottom
of the thread on the tyre's air valve.
8. Plug the electrical cable into the closest 12
V socket and start the car.
NOTE
Make sure that none of the other 12 V sock-
ets is in use when the compressor is operat-
ing.
WARNING
Do not leave children in the car without
supervision when the engine is running.
9. Start the compressor by flicking the switch to
position I .
WARNING
Never stand next to the tyre when the com-
pressor is running. If cracks or unevenness
arise then the compressor must be switched
off immediately. The journey should not be
continued. Contacting an authorised tyre cen-
tre is recommended.
NOTE
When the compressor starts, the pressure
can increase up to 6 bar but the pressure
drops after approximately 30 seconds.
10. Inflate the tyre for 7 minutes.
IMPORTANT
Risk of overheating. The compressor must not
run for more than 10 minutes.
11. Switch off the compressor to check the pres-
sure on the pressure gauge. Minimum pres-
sure is 1.8 bar and maximum 3.5 bar.
(Release air with the pressure reducing valve
if the tyre pressure is too high.)
WARNING
If the pressure is below 1.8 bar then the hole
in the tyre is too big. The journey should not
be continued. Contacting an authorised tyre
centre is recommended.
12. Switch off the compressor and unplug the
electrical cable.
13. Unscrew the air hose from the tyre's air valve
and refit the dust cap on the tyre.
Refit the cover
27
over the tyre's air valve with
the hole towards the wheel hub. Two clicks
confirm that the cover is fitted in place.
14. Fit the protective cap on the air hose in order
to avoid leakage of the remaining sealing
fluid.
27 Only 17" wheel Thia