Volvo V 90 Cross Country, Руководство пользователя, Страница: 495 / 594

WHEELS AND TYRES
}}
493
10. Switch off the compressor to check the pres-
sure on the pressure gauge. Minimum pres-
sure is 1.8 bar and maximum 3.5 bar.
(Release air with the pressure reducing valve
if the tyre pressure is too high.)
WARNING
If the pressure is below 1.8 bar then the hole
in the tyre is too big. The journey should not
be continued. Contacting an authorised tyre
centre is recommended.
11. Switch off the compressor and detach the
electrical cable.
12. Unscrew the air hose from the tyre valve and
refit the dust cap on the tyre.
13. Fit the protective cap on the air hose in order
to avoid leakage of the remaining sealing
fluid.
14. As soon as possible, drive at least 3 km at a
maximum speed of 80 km/h (50 mph) so
that the sealing fluid can seal the tyre.
NOTE
Sealant will spurt out of the puncture during
the first few rotations of the tyre.
WARNING
Make sure that nobody is standing near the
car and gets the sealing fluid splashed onto
them when the car is driven away. The dis-
tance should be at least two metres.
15. Follow-up inspection
Connect the air hose on the tyre valve and
screw in the valve connection to the bottom
of the tyre valve's thread. The compressor
must be switched off.
16. Read the tyre pressure on the pressure
gauge.
•
If it is below 1.3 bar then the tyre is insuf-
ficiently sealed. The journey should not be
continued. Contact a tyre centre.
•
If the tyre pressure is higher than 1.3 bar,
the tyre must be inflated to the pressure
specified in accordance with the tyre
pressure label on the driver side door pil-
lar (1 bar = 100 kPa). Release air using
the pressure reducing valve if the tyre
pressure is too high.
17. If the tyre needs to be inflated:
1. Connect the electrical cable to the closest
12 V socket and start the car.
2. Start the compressor and inflate the tyre
to the pressure specified in accordance
with the tyre pressure label.
3. Switch off the compressor.
18. Remove the tyre sealing equipment, fit the
protective cap on the air hose and fold the
hose in the box.
Place TMK in the cargo area.
WARNING
Do not unscrew the bottle, it is equipped with
a reverse catch to prevent leakage.