Volvo S90 TWIN ENGINE, Руководство пользователя

Страница: 152 / 662

||
LIGHTING
150
Main beam
Main beam can be activated when the steer-
ing wheel stalk switch's rotating ring is in
position
2
or . Activate main
beam by moving the stalk switch forwards.
Deactivate by moving the stalk switch back-
wards.
When main beam has been activated the
symbol illuminates in the driver display.
Related information
•
Lighting control (p. 146)
•
Active main beam (p. 150)
Active main beam
Active main beam is a function which uses a
camera sensor at the top edge of the wind-
screen to detect the headlamp beams from
oncoming traffic or the rear lights of vehicles in
front, and then switches from main beam to
dipped beam.
Active main beam is activated with the rotating ring on
the stalk switch in position
.
The function can also take streetlights into
account. Main beam is reactivated when the cam-
era sensor no longer sees any oncoming vehicles
or vehicles ahead.
The function can start while driving in the dark
when the car's speed is approx. 20 km/h (approx.
12 mph) or higher.
If active main beam is deactivated while main
beam is on, the lighting is immediately reset to
dipped beam.
When active main beam is activated, the symbol
illuminates with a white glow in the driver
display.
When main beam is activated, the symbol shines
blue. This also applies for LED headlamps if the
main beam is partially dimmed, i.e. if the light
beam shines with slightly more than dipped
beam.
2 When dipped beam is activated.