Volvo S90 - ACCESSORY PANEL, Дополнение к руководству пользователя

Страница: 125 / 166

PRACTICAL INFORMATION
123
NOTE
When putting the plastic cover over the hinge
back in place:
•
The pin in the clip must be pressed back
far enough so that it sticks out of the clip
before the clip is used to reinstall the
plastic cover.
•
When the hinge's plastic cover is put in
position, press the plastic clip into the
hole in the cover.
•
Press the pin into the plastic clip until its
end is flush with the surface of the clip.
1. Remove the bulb holder by turning it a quar-
ter turn counterclockwise and pulling it out.
2. Remove the defective bulb by pressing it in
and turning it counterclockwise.
3. Insert a new bulb by pressing it in and turn-
ing it clockwise.
4. Wipe the new bulb with a clean cloth to
remove any grease, etc.
5. Insert the bulb holder by turning it a quarter
turn clockwise.
6. Put the panel and plastic cover over the
hinge back in place in the reverse order.
NOTE
Rear fog lights are not available on all models
or in all markets.
Related information
•
Bulb specifications (p. 123)
Bulb specifications
The following specifications apply to models
equipped with halogen headlights
11
and rear fog
lights. If other bulbs need to be replaced, con-
tact a trained and qualified Volvo service techni-
cian.
Function
[W]
A Type
Low beam 55 H11
High Beam 65 H9
Front turn signal 24 PY24W
Daytime running light/
parking light 21/5 W21/5W
Rear fog light
B 21 H21W LL
A Watt
B Rear fog lights are not available on all models or in all markets.
Related information
•
Replacing bulbs (p. 116)