7
IMG-282410
Place the connector in the bottom of the hole. The guide hole (1)
in the connector's circuit board must align in the corresponding
pin at the bottom of the holder and the holes (2) in the circuit
board must be over the holder's screw turret.
8
IMG-282411
Take the small torx screws and carefully tighten the connector to
the holder. Ensure that the connector's circuit board is properly
against the screw turret and that there is no play.
Remove the butyl tape from the screws.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Navigation system, portable- 30756303 - V1.5
Page 8 / 67
