Volvo Penta D3-110i-A, Руководство оператора

Страница: 65 / 100

63
Maintenance: Seawater system
Cleaning seawater filter
WARNING! Risk for water penetration.
1. Screw off the cover (1).
2. Remove the seal plate (2).
3. Lift out and clean the insert (3).
IMPORTANT! If the boat is used in water that has
a lot of contaminants, seaweed etc. the filter must
be checked more frequently than indicated in the
maintenance schedule. Otherwise there is a risk
the filter will clog and the engine will overheat.
1
2
3
Vacuum valve. Cleaning
Some engines have a vacuum valve installed in the
seawater piping.
WARNING! Risk for water penetration. Close the
sea cock.
For the vacuum valve to work satisfactorily, it must be
taken to pieces twice a season, or when leakage
occurs.
Remove the entire valve from the bulkhead where it is
installed.
Undo the lid of the valve, remove the gasket and
diaphragm and remove any deposits. If the diaphragm
is distorted, put a new one in.
Installation must always be done with the valve
upside down.
Put the diaphragm in the lid. Make sure
that the entire diaphragm rests where it should. The
diaphragm must not be pinched by the gasket. Put the
gasket on and screw the lid on. Note! Tightening torque
(0.2 kpm). If the lid is tightened too much, the valve
stops working.