© Voltex Electrical 2015. All Rights Reserved.
®
10.
Use the template card provided as a hole cutting template to mark out the
intended hole for mounting the appliance (it may be safer to mark the
position from above the ceiling where obstructions are clearly visible,
rather than from inside the room).
11.
Carefully cut around the line. Several holes drilled at a point inside the
marking will provide a convenient starting point for cutting the panel out.
12.
Remove all lamps from the appliance being careful not to damage the
lamps when removing, storing or replacing. Unfasten the internal facia
retaining springs inside the housing. Remove the facia.
13.
Unscrew the terminal cover and make the electrical connections (as per
Figure 1. Wiring diagram below). Once the wiring is connected, replace the
terminal cover and locate cabling to allow room for the appliance to be
positioned in the ceiling cavity.
14.
Choose an optimal direction to insert the housing into the hole in
accordance with the position of fan outlet.
15.
Push the body of the appliance into the hole in the ceiling duct side fi
r
st.
Pull the spring clips inward to avoid damage to the ceiling, then release so
the spring clips can grip. Ensure that the appliance is held securely by the
clips.
16.
If adequate support is not available for the appliance, it may be necessary
to provide extra strengthening. Screws may be used to aid in holding the
unit in the ceiling. Screw holes are located in the flange of the housing
for
this purpose.
17.
Hold the Fascia against the body of the heater and the ceiling and attach
the securing spring clips to hold the Fascia in place.
18.
Replace the lamps – ensure they are tightened sufficiently
t
o make good
electrical contact but don’t overtighten. Clean all lamps ensuring no finge
prints or oil residues are left on the heat lamps after insertion.
19.
Unscrew the terminal cover and make the electrical connections as per the
Wiring Diagram below. Once the wiring is connected, replace the terminal
cover and locate cabling to allow room for the appliance to be positioned in
the ceiling cavity.
20.
Secure wiring away from the housing.
21.
Secure the free end of the ducting to the outlet of the appliance.
22.
WARNING: The appliance shall, under no circumstances, be covered with
insulating material or similar material.
23.
After installation ensure that any drain holes are free from obstruction.
24.
Switches and other controls must not be located where they can be
touched by a person in the bath or shower.
25.
Reconnect the power.
26.
Switch on appliance and check correct function and switch operation.
27.
Your installation is now complete.
