25
• You can wait until the base station has found the remote sensor or you press the button
“
SYN
”
(21) inside the battery compartment (20) of the remote sensor. The syncing starts
immediately.
11. SETTING DISPLAY LANGUAGE
You can switch the display language between German and English.
• Press and hold the button
“C/F”
(4) for about 3 seconds.
• The display switches between German and English.
12. SETTING TEMPERATURE UNIT
• Briefly push the button “C/F” (4) at the base station to switch the temperature unit between °C
(degrees Celsius) and °F (degrees Fahrenheit).
• To switch the remote sensor display between °C and °F, briefly push the button “C/F” (19) in the
battery compartment of the remote sensor (20).
The setting of the temperature unit for base station and remote sensor is independant.
13. SETTING MIN/MAX TEMPERATURE VALUES
1. Press the button
“
SET
”
(3) to enter the setting mode. The symbol SET lights up in the LC display
of the base station and the MAX value starts blinking.
2. Use the buttons
“
+
”
(5) or
“
-
”
(6) to set the desired temperature value. The default temperature
value is -50 °C.
3. Press afterwards the button
“
SET
”
(3) to set the MIN value.
4. Use the buttons
“
+
”
(5) or
“
-
”
(6) to set the desired temperature value.
5. Press the button
“
SET
”
(3) to save the values and exit the setting mode.
When the measured temperature of the remote sensor drops below or exceeds the set
values, the backlight of the base station starts blinking and the buzzer becomes active.
Press the button
“
BACKLIGHT/ALERT STOP
”
(2) to deactivate the alarm. The buzzer is
deactivated by default.
When the temperature drops below -50 °C or e120 °C, the LC display shows
“
Lo
”
or respectively
“
Hi
”
.
Press and hold the button
“
BACKLIGHT/ALERT STOP
”
(2) for approx. three seconds
in order to activate/deactivate the buzzer. One single beep means, that the buzzer is
deactivated. Two beeps mean, that the buzzer is activated.
Содержание TM-500RF
Страница 55: ...55...