Digital Storage Oscilloscope 44
Moving Cursors:
Press the key near Select Cursor to select a cursor and turn
Universal Knob
to move it. Cursors can be moved only when the Cursor Menu is
displayed.
2.10.3 Automatic Measurement
Automatic Measurement:
The oscilloscope performs all the calculations automatically
in this mode. As this measurement uses the waveform record points, it is more precise
than the graticule and cursor measurements. Automatic measurements show the
measurement results by readouts which are periodically updated with the new data
acquired by the oscilloscope.
Push the
MEASURE
button to perform auto measurements. There are 32 types of
measurements and up to 4 can be displayed at a time.
Perform the steps below and select voltage or time parameters to make automatic
measurements.
1. Press the
[MEASURE]
button on the front panel to enter the MEASURE function
menu.
2. Press the
Source
softkey, and then use the
Universal Knob
to select the desired
channel.
3. To select and display measurement parameters. Press the
Type
softkey, and then
turn the
Universal Knob
to select the desired measurement parameter.
4. Press the
Universal Knob
to add the measurement parameter, the parameters and
value will be shown above the menu, and the statistics status will update.
5. To turn off the statistic function, press the
Statistics
softkey to select OFF.
The measurement display area can display 4 measurement parameters at most, and
the measurements will arrange according to the selecting order. If add a sixth
measurement parameter, it will delete the first measurement.
Note:
If the parameter does not match the measured condition, it will display as
“*****”.
To Clear Measurement Parameters
Press the
Clear All
softkey to clear all the measurement parameters that are displaying
on the screen.
