50
Follow the steps below to measure DC currents (A ):
- Switch on the DMM and select “10A, mA, or µA” mode.
- The table shows the different measuring modes and the corresponding measurement ranges. Select the desired
measurement range and connect the corresponding terminals.
Measurement mode
Measurement range Terminals
µA
<4000 µA
COM + mAµA
mA
4000 µA – 399 mA
COM + mAµA
10A
400 mA – 10 A
COM + 10A
- Insert the red lead into the mA µA or 10 A terminal. Plug the black test lead into the COM terminal.
- Connect the two measuring probes in series to the object that you want to measure (e.g. battery or circuit). The
electrical circuit must be disconnected before you connect the probes.
- Reconnect the circuit. The measurement will appear on the display.
-
After measuring, disconnect the circuit and remove the test leads from the measured object. Switch off the multimeter.
