CARE AND MAINTENANCE :
STORAGE AND CLEANING
If your kick
‐
scooter gets dirty, please clean it with a damp cloth. (you can use a stiff brush first to get the worst
dirt off and then use a cloth afterwards to clean it.). It is also possible to use a little toothpaste if the
dirt is stuck. Remember to clean with damp cloth after this.
Please make sure to keep the kick scooter turned off while cleaning it, and make sure to cover the charging
input to avoid problems with the electronics.
Please notice: Do not use alcohol, gas, kerosene or other corrosive and volatile chemical solvents. This can
damage both the appearance and the internal structure of the kick scooter. You may not use pressured
water
‐
gun or running water either.
Please store your kick scooter in a dry and cool environment when not in use. Avoid leaving it
outdoors, as it is not made for use in wet areas. Nor is it good to expose to high temperatures
caused by direct sun for a long time.
MAINTENANCE OF BATTERIES
Please make sure the batteries do not get over 50° Celsius, or under 20° Celsius for a longer period of time. (e.g
don’t leave the kick scooter in a hot car in summer, do not put batteries into fire et.) Low temperature (e.g.
subzero temperature) can damage the battery cells.
Please avoid draining the batteries 100%. It is best to charge them while there is still power on them. This will
extend battery life. Also if riding the kick scooter in cold or very hot areas, the battery time can be lower than
when riding in temperatures from 15
‐
25° Celsius. This is not a failure on the batteries, but are normal
behavior.
Please notice: Even fully charged batteries will run out of power if the kick scooter is not used for a period of
time. Expect between 90 and 120 days in off mode if batteries are fully charged. If only partially charged, this
period of time is lower.
Please make sure to charge the batteries before they are 100% out of power, to avoid damaging the battery
cells. (damaged battery caused by wrong handling are not covered by warranty)
It is forbidden to disassemble battery package. This is only to be handled by official service repair centers and
professionals.
BEARING
Your scooter is equipped with precision bearings greased during manufacture. The bearings do not require
maintenance but are wearing parts. Warning ! Worn bearings make clearly audible noises and their functions are
reduced. To maintain driving pleasure and ensure long-lasting safety, replace them.
CHANGE OF WHEELS
The wheels must be changed when they are worn. To change the wheels, remove the axle bolting with two
hexagon socket wrenches and remove the wheel from the axle. You can pull the ball bearing out of the wheel by
tapping it with a screwdriver or hex key to continue using it in the new wheel. But in general it is advisable to
make a change of bearing at the same time as the wheel change.
Replace the bearing with the spacer sleeve in the new wheel and mount it on the frame with the axle bolts.
Check that the axle is firmly bolted before leaving!
WARNING
Always check parts and tightening mechanisms before each use. Do not use the scooter if parts are broken and
/ or damaged. Do not modify your scooter, do not use second-hand parts that are not from the manufacturer.
Be careful, self-locking nuts and other anti-loosening fasteners may lose their effectiveness over time. For your
safety, check them regularly and replace them if necessary.
It is recommended to clean and dry the scooter after each use. The scooter will be stored in its original
packaging when it will not be used. It will be stored away from corrosive products.
The manufacturer can not be held responsible for any modification resulting from a use other than that specified
in this documentation.
