VOLTA Sleeve Mounting System
1.
Sleeve Mounting Adapter-designed for use with a specific O.D. sleeve.
2.
Sleeve Mounting Jig
3.
Roller support
4.
Push bar
5.
Hose clamp
Safety Instructions:
1.
The VOLTA Sleeve Mounting System operates
using compressed air. One should not stand
in the area directly in front of or behind the jig.
If the roller is accidentally forced out of the
front of the sleeve or the handle is forced
backwards, this could result in injury.
2.
Ensure that the sleeve has been mounted
above the rim of the Adapter and that the hose
clamp is tightly secured around the sleeve.
3.
The system requires at least 1 bar of pressure
to operate. Pressure must
not
exceed 3.5 bar.
4.
The air pressure must be adjusted relative to
sleeve diameter (higher for larger diameters).
Carefully increase the air pressure, adding
just sufficient pressure to permit the mounting
of the sleeve without undue force.
5.
Ensure that the regulator controlling pressure
is in good condition and is calibrated.
6.
For maximum safety only use handles
manufactured by VOLTA Belting Technology
Ltd that have pressure release holes as
shown above.
The VOLTA Sleeve Mounting System can be used to mount VOLTA Sleeves on rollers of most lengths found in industry.
The VOLTA Sleeve Mounting System is depicted here and consists of:
3
2
4
5
1
Note:
The Sleeve Mounting Adapter(1) can be mounted in a vice instead of the sleeve jig.
3
