INSTALLATION INSTRUCTIONS
[email protected] • 813.978.3700
w w w . v o l t l i g h t i n g . c o m
- 4 -
- 5 -
Install Stake
1
Board
Stake
Soil
Ground
Determine the desired location for
mounting the fixture. Hammer the stake
into the ground until flange of stake is
flush to grade. To avoid damage to the
stake, place a board on top of the stake
while hammering.
NOTE: If the ground is hard and the stake
is difficult to install, make a crosscut in
the ground using a flat shovel.
Wire Connections
3
Strip both leads from the luminaire pigtail. Using two wire
connectors (sold seperately), connect the leads from the luminaire
to the main supply cable leads.
Pigtail
Main Supply Cable
Wire Connectors
Clear away an area in the ground at
the wireway slot on top of the stake.
Lay the luminaire pigtail into the
wireway slot and thread the fixture
onto the stake.
Thread the lock nut at the bottom
end of the fixture against the stake
and hand tighten.
Install Fixture to Stake
2
Pigtail
Wireway Slot
Lock Nut
Fixture
VOLT
®
Brass ShadowMaster™ LED Path & Area Light
VPL-1039-BXX
