25
5.3 TROUBLESHOOTING - FREEZER
PROBLEM
1. Power to machine is off.
1. Check power to machine.
2. Low line voltage.
2. Check, must be ±10% of nameplate voltage.
3. Product too hard.
3. Raise overrun. (See Section 4.8)
4. Front door not installed securely.
4. Install front door securely.
1. Power to machine if off.
1. Check power to machine.
2. Low line voltage.
2. Check, must be ±10% of nameplate voltage.
3. Compressor internal overload is cut-
out.
3. Check condenser (air cooled)(See Sect. 4.13),
or water supply (water cooled).
4. Front door not installed securely.
4. Install front door securely.
1. CutOut setting is too low
1. Adjust CutOut setting to match product
requirements.(See Section 3.10)
2. Product break down.
2. Fill with fresh product.
1. CutOut setting is too high.
1. Adjust CutOut setting to match product
requirements.(See Section 3.10)
2. Low overrun setting.
2. Raise overrun. (See Section 4.8)
3. Low pump pressure.
3. Check pump pressure.
4. Large air pocket in barrel.
4. Purge air from barrel.
5. Auger turning counter-clockwise.
5. Change rotation to clockwise.
1. Seal missing or installed wrong.
1. Install correctly. (See Section 3.8)
2. Rear seal o-ring missing, broken or not
lubricated.
2. Inspect for breakage and lubricate properly
(See Section 3.8)
3. Worn or scratched shaft.
3. Replace shaft.
1. Spigot parts are not lubricated.
1. Lubricate. (See Section 3.13)
2. Chipped or worn o-rings.
2. Replace o-rings.
3. O-rings on spigot installed wrong.
3. Remove spigot and check o-rings.
4. Nicks or scratched on front door where
spigot is located.
4. Replace front door.
1. Drive belt tension not correct.
1. Adjust belt tension. (See Section 4.12)
2. Worn belt(s).
2. Replace belts.
3. Low overrun.
3. Check for air leak.
1. Temperature control set too warm.
1. Decrease CabCtOut and CabCutIn (See
Section 4.7)
2. Cab door is open.
2. Close the cab door.
Mix temperature
too cold in cab.
1. Temperature control set too cold.
1. Increase CabCtOut and CabCutIn (See Section
4.7)
Drive motor (auger)
"kicks-out", or does
not run.
Compressor does
not operate.
Product too soft.
Freeze-up.
(Product will not
dispense easily.)
Rear auger seal
leaks.
Spigot leaks.
POSSIBLE CAUSE
REMEDY
Drive belts slipping
or squealing.
Mix temperature
too warm in cab.
Содержание STOELTING O431RC
Страница 1: ...Model O431RC OPERATORS MANUAL Manual No 513664 Rev 2 ...
Страница 2: ......
Страница 34: ...28 ...
Страница 38: ...32 ...
