Vollrath Stoelting F231-2X, Руководство оператора

Страница: 14 / 28

Owner’s Manual #513707 8 F231-2X Model Machines
Help
Pressing the Help button displays help information depen-
dent on the cursor’s location. Pressing the Help button
again exits the help screen.
Selection Button (SEL)
The SEL button is used by technicians to select menu
options.
Set Button (SET)
The SET button is used by technicians to save changes
when modifying control settings.
On/Off Button
Power to the freezing cylinders can then be controlled
with the On/Off Left and On/Off Right switches.
Push to Freeze Button
Pressing the PUSH TO FREEZE button initiates “Serve
Mode”.
Clean Button
The CLEAN button initiates “Clean Mode”.
Arrow Buttons (

)
The arrow buttons are used by technicians to navigate
through the control readings and settings.
B. DISPENSE RATE ADJUSTOR
The dispense rate adjustor is located under the header
panel, to the immediate right of the spigot handles. Turning
the knob counterclockwise decreases the dispense rate.
C. USB ACCESS PORT
The USB access port is located on the right side panel
of the machine. The port is used by technicians to import
fi rmware and export machine statistics.
D. LOW MIX ALARM (OPTIONAL)
An audible alarm will sound when the mix level in the hop-
per is low. Fill the hopper with mix to silence the alarm.
3.3 EMPTYING THE FREEZING CYLINDER
If the machine is empty, go to Section 3.4.
A.
Make sure the Main Freezer Power is on. If the
IntelliTec2™ displays the Current Status Screen,
then the main power is on.
B. Turn off the freezing cylinders by pressing the
On/Off buttons.
C. Remove the hopper covers and remove the mix
inlet regulators from the hoppers.
D. Press the Clean button. After about 5 minutes
open the spigot to drain the mix.
E. Press the Clean buttons to stop the augers.
F. Fill each hopper with 1 gallon of cool tap water.
Optional: Use detergent solution instead of tap
water to make cleaning the parts easier after
disassembly.
G. Press the Clean buttons and let the augers rotate
for at least 30 seconds.
H. While the augers are rotating, scrub the hoppers
with a clean brush.
I. Drain the water out of the machine.
J. Press the Clean buttons again to stop the auger.
NOTE
If the water does not drain clear, repeat steps F
through J.
3.4 DISASSEMBLY OF MACHINE PARTS
Before using the machine for the fi rst time, complete
machine disassembly, cleaning, and sanitizing proce-
dures need to be followed. Routine cleaning intervals and
procedures must comply with the local and state health
regulations. Inspection for worn or broken parts should
be made at every disassembly of the machine. All worn
or broken parts should be replaced to ensure safety to
both the operator and the customer and to maintain good
machine performance and a quality product. Check the
wear line on the auger fl ights on a regular basis (Fig. 3-3)
and replace as needed.
To disassemble the machine, refer to the following steps:
NOTE
The hopper covers have compartments for all
freezing cylinder parts. The covers help with parts
identi
fi cation and prevent loss of parts. After dis-
assembly, place the freezing cylinder parts in the
hopper covers to transport them to and from the
washing station.
Figure 3-2 IntelliTec2 Control
Wear Line
Figure 3-3 Auger Flight Wear