Vollrath Stoelting F212, Руководство оператора

Страница: 18 / 23

Operators Manual #513675 12 F212 Model Machines
4.2 TROUBLESHOOTING - CONTINUED
PROBLEM POSSIBLE CAUSE REMEDY
Product is too thin.
1 Temperature setting too warm. 1 Adjust the Temperature Adjustment Screw
(Section 3.2)
2 No vent space for free fl ow of cooling
air. 2 A minimum of 3” of air space at the sides.
3 Condenser is dirty. 3 Clean the condenser. (See Section 3.13)
4 Auger is assembled incorrectly. 4 Remove mix, clean, reassemble, sanitize and
freeze down.
5 Refrigeration problem. 5 Check system. (Call a service technician)
Product does not
dispense or it is
a very slow draw
rate.
1 No mix in hopper. 1 Add mix to the hopper
2 Auger is not turning 2 Check system. (Call a service technician)
3 Mix inlet regulator is obstructed or
clogged. 3 Clean the mix inlet regulator and make sure
the mix is fully thawed.
4 Front door has frozen product or is
clogged. 4 Turn Clean/Off/On switch to Clean for 5
minutes, then restart.
Drive belt slipping
or squealing.
1 Not tensioned properly. 1 Adjust belt tension
2 Worn drive belt. 2 Replace drive belt.
3 Freeze-up (Auger will not turn). 3 Turn Clean/Off/On switch Off for 15 minutes,
then restart.
Rear auger seal
leaks.
1 Outside surface of rear auger seal is
lubricated. 1 Clean lubricant from outside of rear seal and
rear of the freezing cylinder. Lubricate the rear
seal o-ring and reinstall the auger (See Section
3.11)
2 Rear seal missing or damaged. 2 Check or replace.
3 Seal o-ring missing or damaged. 3 Check. or replace.
4 Worn or scratched auger shaft. 4 Replace auger shaft.
Front door leaks.
1 Front door knobs are loose. 1 Tighten knobs in a crisscross pattern.
2 Spigot o-rings are not lubricated. 2 Lubricate the spigot o-rings
3 Chipped or worn spigot o-rings. 3 Replace o-rings.
4 Inner spigot hole in front door nicked
or scratched. 4 Replace front door.