Vollrath Stoelting F212, Руководство оператора

Страница: 17 / 23

Operators Manual #513675 11 F212 Model Machines
SECTION 4
TROUBLESHOOTING
4.1 LIGHT INDICATORS
The machine has two lights that will alert the user if a problem occurs: an ADD MIX light and a Diagnostic Light.
The ADD MIX light will fl ash to alert the operator to a low mix condition. It does so by monitoring the mix level in the
hopper. When the ADD MIX light is fl ashing, refi ll hopper immediately.
The Diagnostic Light will fl ash if an error occurs. Refer to the chart below for details.
4.2 TROUBLESHOOTING
Indication On One Blink Two Blinks Three Blinks
Conditions Standby Mode
Torque is not
met after 22
minutes
Drive current is not sensed
Machine left in clean
mode for over 20
minutes
Self
Correction
N/A N/A
The machine attempts to sense drive
current with a 3 second pre-stir. If
current is sensed, the machine will return
to normal operation. If current is not
sensed, the machine will wait 7 minutes
and try to sense current with another 3
second pre-stir. After the third attempt,
the compressor will run on timers.
N/A
Operation
Every 10
minutes the
machine will run
for 30 seconds.
Timers or until
the consistency
sensor is
satisfi ed.
Timers Off
Corrective
Action
Standby Mode
ends when the
spigot is opened
or when the
CLEAN-OFF-
ON switch is
moved to OFF
position then to
the ON position
Check the
condenser
(Section 3.13).
Make sure
the auger
is installed
correctly
(Section 3.11).
Contact Service
Technician
Contact Service Technician
Turn CLEAN-OFF-
ON switch to OFF
(middle) position then
turn the switch to ON.
PROBLEM POSSIBLE CAUSE REMEDY
Machine does not
run.
1 Power to machine is off. 1 Supply power to machine.
2 Blown fuse or tripped circuit. 2 Replace or reset.
3 Freeze-up (auger will not turn). 3 Turn Clean/Off/On switch Off for 15 minutes,
then restart.
4 Front door not in place. 4 Assemble front door in place.
Product is too fi rm.
1 Temperature setting is too cold. 1 Adjust the Temperature Adjustment Screw
(Section 3.2)