6 Mirage
®
Induction Buffet Warmers Operator’s Manual
CONNECTING THE WARMERS
Connect up to three warmers with the included interconnect cords. The
center warmer must be connected to the electrical outlet.
16 x 16 Warmer
s
16 x 23 Warmers
1. Plug one warmer into a grounded electrical outlet with the matching
nameplate rated voltage.
2. Plug one end of the interconnect cable into the side of the warmer
connected to the electrical outlet.
3. Plug the other end of the interconnect cable into the operator side of
the second warmer.
NOTICE: The induction warmer connected to electrical supply
must remain turned on to supply power to side-
connected equipment.
CLEANING
To maintain the appearance and increase the service life, clean your
Mirage® Buffet Induction Warmer daily.
1. Unplug the equipment and let it completely cool.
2. Wipe the equipment exterior with a clean damp cloth.
NOTICE: Do not use abrasive materials, scratching cleansers or
souring pad to clean the equipment. These can damage
the finish.
NOTICE: Do not spray controls or outside of equipment with
liquids or cleaning agents.
3. Thoroughly wipe off any mild soap or chemical cleaners. Residue
could corrode the surface of the equipment.
A
Power Supply Cord
B
Interconnect Cable
B
A
B
B
A
B
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock. Do not spray water or cleaning products.
Liquid could contact the electrical components and cause a
short circuit or an electrical shock. If liquid spills or boils over
onto the unit, immediately unplug the unit and remove serving
vessel. Wipe up any liquid with a padded cloth.
CAUTION
Burn Hazard
Do not touch serving vessel, heating surface, food or liquid
while heating. Hot food and liquids can burn skin. Induction
heating surfaces heat very rapidly. Allow the heating surface to
cool before handling.