4
HOT FOOD DISPLAY
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT SPRAY OUTSIDE OF THE UNIT OR CONTROLS WITH LIQUID OR
CLEANING PRODUCT. LIQUID COULD ENTER THE ELECTRICAL
COMPARTMENT AND CAUSE A SHORT CIRCUIT OR ELECTRIC SHOCK.
Cleaning:
1. Insure that the unit is unplugged and completely cool prior to cleaning.
2. Place a suitable container under the drain valve.
3. Carefully open drain valve to drain water from the basin.
4. Unit must not be cleaned with a water jet or immersed in water.
5. Use a damp cloth or sponge dipped in mild soapy water to wipe the interior and
exterior surfaces; thoroughly rinse.
6. Exterior of unit must be completely dry before plugging back in.
7. In areas of hard water, residue can build up in the basin or on the heating
element. De-liming agents must be used in accordance with manufacturer’s
instructions. BE SURE TO RINSE COMPLETELY TO REMOVE ALL CHEMICAL
RESIDUES. Chemical residue can cause the basin to corrode and can
contaminate the food.
8. Do NOT use chloride or chloride based products for cleaning. This will damage
the stainless steel surfaces.
Repair and Maintenance:
CAUTION
CUT INJURY HAZARD
WEAR PROTECTIVE GLOVES AND PROTECT YOUR
EYES WHEN REPLACING THE HEAT LAMPS. THE
LAMP COULD SHATTER WHEN REMOVING OR
INSTALLING.
Replacing heat lamp
1. The heat lamps in the appliance are standard 120V, 1000W tungsten halogen
lamps.
2. Allow the appliance and the lamps to fully cool down before attempting to replace
the lamps.
3. Disconnect the appliance from the electrical power source.
4. To remove the lamp, push the lamp towards one end to release the opposite end
and pull the lamp out. This may require some force as the lamp is held in position
with spring tension.
5. When inserting a new lamp, do not touch the glass with your fingers as this
reduces its life and efficiency. Use a clean, dry cloth or something similar to hold
the lamp while installing.
There are no other user serviceable parts
within this food display. To avoid serious
injury or damage, never attempt to repair or replace a damaged power cord yourself.
Contact a qualified professional repair service.
