Volkswagen ID.4, Руководство пользователя

Страница: 298 / 417

8. Check to see if a fuse has visibly blown
→ page 296.
9. Follow the instructions to change the af-
fected bulb → . Always replace bulbs
with identical bulbs of the same type.
The designation is inscribed on the bulb,
either on the glass part or on the base.
10. Do not touch the glass part of the bulb
with unprotected fingers. When switch-
ed on, the heat of the bulb would cause
the remaining fingerprint to evaporate
and be deposited on the reflector. This
will impair the light output of the head-
light.
11. After changing a bulb, check to ensure
that the bulb is working properly. If the
bulb is not working properly, the bulb
may not have been inserted properly,
may have failed again, or the connector
may have been fitted incorrectly.
12. Each time you change a bulb at the front
of the vehicle, the headlight settings
should be checked by a qualified work-
shop.
WARNING
Ignoring any of the items on this important
safety checklist can lead to accidents and
severe injuries.
·
Always follow the instructions in the
checklist and observe the general safety
procedures.
NOTICE
Always take care when removing or fitting
lights to prevent damage to the paintwork or
to other vehicle parts.
Changing the turn signal bulb
Please refer to and at the start of
the chapter on page 295.
Fig. 159 Rear of the right headlight: changing
the turn signal bulb.
The actions should only be carried out in the
specified order:
1.
Observe and follow the instructions in
the checklist → page 295.
2. Open the bonnet → page 309.
3.
Turn the bulb holder → Fig. 159
1
in
the direction of the arrow and pull it out.
4. Replace the defective bulb with a new
bulb of the same type.
5. Carefully insert the bulb holder into the
headlight and turn it as far as it will go in
the opposite direction to the arrow.
6. Close the bonnet → page 309.
The illustration shows the right-hand
headlight from the rear. The left-hand
headlight is a mirror image of the one shown.
Changing fuses
Introduction to the topic
At the time of publication we are unable to
provide an complete overview of the loca-
tions of the fuses for the electrical consum-
ers. This is because the vehicle is under con-
stant development, because fuses are as-
296 If and when