Fig. 173
Driver's door control to open and close all windows.
¤
Please first read and note the introductory information and heed the WARNINGS
.
Before emergency closing
, make sure the
preliminary requirements
for
normal
CSC roof closing
are met,
CSC roof
.
If the CSC roof still cannot be closed even if the preliminary requirements have been met, or, if all the
requirements cannot be met, it may still be possible to perform the emergency closing procedure for
the CSC roof.
The indicator light
X
may be flashing in the instrument cluster. In addition, there may be a text
message in the instrument cluster display that gives instructions as to what to do.
Possible situations for emergency closing
Provided the preliminary requirements have been met, the CSC roof can be closed using the
emergency procedure if you have one or more of the following problems:
x
The windows in the doors will not go down.
x
The soft-close feature of the luggage compartment lid is not working.
x
Sensors that determine the position of the CSC roof when it is opening and closing are not
working.
Emergency CSC roof closing
x
Check whether there is enough room behind the vehicle for the luggage compartment lid to swing
out backwards.
x
Open the driver and passenger door and leave the doors open.
x
Press your thumb on the top part of the Volkswagen emblem on the luggage compartment lid, and
flip lower part of the emblem outward. This unlocks the rear lid. But
do not
lift the luggage
compartment lid.
x
Switch the ignition off and back on again.
x
Start the engine.
x
Pull and hold the center console lever
⇒
fig. 172
for at least 30 seconds.
x
Release the lever.
x
Pull and hold the lever again and immediately pull back and hold the driver door switch
⇒
fig. 173
(1)
until the CSC roof has completely closed and locked.
It takes a few seconds for the closing process to start after you pull both controls. A tone sounds and
the indicator light
X
in the instrument cluster display lights up during the emergency closing process.
There may also be a message in the instrument cluster display.
The closing process is immediately
interrupted
if you let go of the lever or the switch or if one of the
cancel conditions changes (
Cancel conditions for emergency closing
). The process can be restarted
by again pulling the center console lever and the switch in the driver door.