Volcano 20-200, Инструкция по эксплуатации

Страница: 7 / 16

7
Installing Propane Attachment
Step 1
• Stand unit upright.
• Remove all grills and grates from the
stove.
• The venting system must be in the
“Open” position before installing the
propane burner.
Step 2
• Place the propane burner in the bottom
of the cooking chamber.
• Attach the brass tube end of the regula-
tor assembly to the burner throat.
• The brass propane tube passes
through the hole above the vent ring as
shown in image 3. If the venting sys-
tem is not in the open position a safety
tab prevents the tube from inserting.
NOTE: DO NOT cross thread the pieces.
• Secure burner while tightening the
regulator assembly to the burner throat.
• Align burner cradle around the four (4)
notches on the bottom of the cooking
chamber. This will limit movement of the
burner cradle.
Step 3
• Place the heat diffuser plate directly
on top of the propane burner cradle.
Step 4
• Place top grill on the body of the unit.
It should overlap and be secured
from shifting.
NOTE: Refer to the “To light” section
on page 8 for instructions on how to
ignite fuel source.
For Charcoal/Wood Grills
Step 1 #20-200 #20-300 GRILLS
• Stand unit upright
Step 2
Ensure venting system is in the “open” position.
Step 3
• Insert the smaller bottom grill into the
bottom of the stove (the grill should sit
approx. 1” above the bottom).
• Place charcoal briquettes or wood on
bottom grill. To raise the heat source
for grilling or to increase the heat, for
cooking see tip below.
Never place fuel source (charcoal or
wood) on the bottom of the cooking
chamber without the grill in place.
Grilling Tip
• For greater heat intensity, insert the
heat diffuser plate into the stove. This
should sit approximately 4-5 inches
from the top grill.
• Place charcoal briquettes or wood on
heat diffuser plate (instead of bottom
grate).
• Light fuel source and place grill on
top of stove.
Opening for brass
propane tube