If the rudder is angled off to the left carefully remove the clevis from the control horn and screw it
‘in’ (clockwise) one half to one full turn then insert the pin back into the outermost hole in the control horn. Or, if
the rudder is angled off to the right carefully remove the clevis from the control horn and screw it ‘out’ (counter
‐
clockwise) one half to one full turn then insert the pin back into the outermost hole in the control horn. View the
vertical tail and rudder from directly above again and continue adjusting the length/position of the pushrod/
clevis until the rudder is centered appropriately.
!
!
NOTE: You should always rotate the clevis until the pin is perpendicular with the control horn to ensure the pin
is not under any excessive load/pressure when inserted in the hole and during operation. In some cases it may
not be possible to ‘exactly’ center the surface mechanically while properly aligning the pin. In these cases be
sure the pin is properly aligned then adjust the position of the trim lever slightly as needed. Also, it will likely be
necessary to make further adjustments to the position of the trim lever during flight as most surfaces do not
end up in exactly the centered position when an airplane is trimmed properly for actual flight (but ‘centered’ is
still the best starting point).
!
!
Follow the same steps outlined for centering the rudder to center the elevator as well.
!
!
!
!
Also, we strongly recommend installing the included
‘clevis keepers’ to provide added security for the
clevises. Typically you can carefully slide the keepers
over the clevises when they are not connected to the
control horn. Then, after connecting the clevis to the
control horn and ‘snapping’ the clevis together you can
slide the keepers into a position that does not allow
them to ‘bind’ against the control horn during movement
of the surface.
!
!
FPV System Deployment
!
Ranger EX is professional FPV / UAV platform which designed for long range FPV, so except the capability of
carrying big size batteries, it also have a lot of potential for all kind of camera installation. Here we are showing
normally camera and UAV equipment deployment, please have a check the image below.
!
!
RANGER EX — Professional FPV Platform
/
7 16
Содержание RANGER EX
Страница 16: ... 2014 VolantexRC Co Ltd ...